Skip to main content
Tagasi

EVS-EN ISO 16810:2024

Non-destructive testing - Ultrasonic testing - General principles (ISO 16810:2024)

Üldinfo

Kehtiv alates 01.11.2024
Alusdokumendid
ISO 16810:2024; EN ISO 16810:2024
Tegevusala (ICS grupid)
19.100 Mittepurustav katsetamine
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
01.11.2024
Põhitekst
01.04.2014
Põhitekst

ISO 16810 specifies the general principles for the ultrasonic testing of industrial products that permit ultrasound transmission. The specific conditions of application and use of ultrasonic testing, which depend on the type of product to be tested, are described in documents

They can include product standards, specifications, codes, contractual documents or written procedures. ISO 16810 specifies the minimum applicable requirements, unless otherwise specified in the referencing documents.

This document does not specify:

— the extent of testing and scan plans,
—  acceptance criteria.

ISO 16810 describes only conventional probes, however, the general principles for ultrasonic testing also apply to ultrasonic testing using array techniques. If array techniques are used, additional steps or verifications can be needed. ISO 16810:2024 text has been approved in Europe EN ISO 16810:2024 without any changes.

Nõutud väljad on tähistatud *

*
*
*
PDF
15,86 € koos KM-ga
PDF redline
20,62 € koos KM-ga
Paber
15,86 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN 13480-5:2024

Metallist tööstustorustik. Osa 5: Kontroll ja katsetamine
Uusim versioon Kehtiv alates 01.11.2024
Muudatus

EVS-EN ISO 12572:2016/A1:2024

Hygrothermal performance of building materials and products - Determination of water vapour transmission properties - Cup method - Amendment 1 (ISO 12572:2016/Amd 1:2024)
Kehtiv alates 01.11.2024
Põhitekst

EVS-EN ISO 18563-3:2024

Non-destructive testing - Characterization and verification of ultrasonic phased array equipment - Part 3: Complete systems (ISO 18563-3:2024)
Uusim versioon Kehtiv alates 15.05.2024
Põhitekst

EVS-EN ISO 19675:2024

Non-destructive testing - Ultrasonic testing - Specification for a calibration block for phased array testing (PAUT) (ISO 19675:2017)
Uusim versioon Kehtiv alates 01.08.2024