Skip to main content
Tagasi

EVS-EN 61952:2008

Insulators for overhead lines - Composite line post insulators for A.C. systems with a nominal voltage greater than 1 000 V - Definitions, test methods and acceptance criteria

Üldinfo

Kehtetu alates 15.07.2022
Alusdokumendid
IEC 61952:2008; EN 61952:2008
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
05.12.2008
Põhitekst
Põhitekst
EVS-EN 61952:2003
This International Standard applies to composite line post insulators consisting of a load-bearing cylindrical insulating solid core consisting of fibres – usually glass – in a resin-based matrix, a housing (outside the insulating core) made of polymeric material and end fittings permanently attached to the insulating core.  Composite line post insulators covered by this standard are subjected to cantilever, tensile and compressive loads, when supporting the line conductors. They are intended for use on a.c. overhead lines with a rated voltage greater than 1 000 V and a frequency not greater than 100 Hz. The object of this standard is –  to define the terms used, –  to prescribe test methods, –  to prescribe acceptance or failure criteria. This standard does not include requirements dealing with the choice of insulators for specific operating conditions.

Nõutud väljad on tähistatud *

*
*
*
PDF
24,40 € koos KM-ga
Paber
24,40 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

IEC TS 60815-1:2008

Selection and dimensioning of high-voltage insulators intended for use in polluted conditions - Part 1: Definitions, information and general principles
Uusim versioon Kehtiv alates 29.10.2008
Põhitekst

EVS-EN 61109:2008

Insulators for overhead lines - Composite suspension and tension insulators for a.c. systems with a nominal voltage greater than 1 000 V - Definitions, test methods and acceptance criteria
Uusim versioon Kehtiv alates 05.12.2008
Põhitekst

EVS-EN 61284:2002

Overhead lines - Requirements and tests for fittings
Uusim versioon Kehtiv alates 01.11.2002
Põhitekst

EVS-EN 61462:2007

Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with rated voltage greater than 1 000 V - Definitions, test methods, acceptance criteria and design recommendations
Kehtetu alates 01.11.2023