Skip to main content
Tagasi

EVS-EN 61109:2008

Insulators for overhead lines - Composite suspension and tension insulators for a.c. systems with a nominal voltage greater than 1 000 V - Definitions, test methods and acceptance criteria

Üldinfo

Kehtiv alates 05.12.2008
Alusdokumendid
IEC 61109:2008; EN 61109:2008
Tegevusala (ICS grupid)
29.080.10 Isolaatorid
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
Põhitekst
prEN IEC 61109:2023
05.12.2008
Põhitekst
This International Standard applies to composite suspension/tension insulators consisting of a load-bearing cylindrical insulating solid core consisting of fibres – usually glass – in a resin-based matrix, a housing (outside the insulating core) made of polymeric material and end fittings permanently attached to the insulating core.  Composite insulators covered by this standard are intended for use as suspension/tension line insulators, but it should be noted that these insulators can occasionally be subjected to compression or bending, for example when used as phase-spacers.  This standard can be applied in part to hybrid composite insulators where the core is made of a homogeneous material (porcelain, resin), see Clause 8.  The object of this standard is to –  define the terms used, –  prescribe test methods,  –  prescribe acceptance criteria.  This standard does not include requirements dealing with the choice of insulators for specific operating conditions.

Nõutud väljad on tähistatud *

*
*
*
PDF
24,40 € koos KM-ga
Paber
24,40 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN 61952:2008

Insulators for overhead lines - Composite line post insulators for A.C. systems with a nominal voltage greater than 1 000 V - Definitions, test methods and acceptance criteria
Uusim versioon Kehtetu alates 15.07.2022
Põhitekst

IEC TS 60815-1:2008

Selection and dimensioning of high-voltage insulators intended for use in polluted conditions - Part 1: Definitions, information and general principles
Uusim versioon Kehtiv alates 29.10.2008
Põhitekst

IEC TS 60815-3:2008

Selection and dimensioning of high-voltage insulators intended for use in polluted conditions - Part 3: Polymer insulators for a.c. systems
Uusim versioon Kehtiv alates 29.10.2008
Põhitekst

EVS-EN 62217:2013

Polymeric HV insulators for indoor and outdoor use - General definitions, test methods and acceptance criteria (IEC 62217:2012)
Uusim versioon Kehtiv alates 02.04.2013