Skip to main content
Tagasi

EVS-EN 12560-2:2013

Flanges and their joints - Dimensions of gaskets for Class-designated flanges - Part 2: Spiral wound gaskets for use with steel flanges

Üldinfo

Kehtiv alates 14.11.2013
Alusdokumendid
EN 12560-2:2013
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
14.11.2013
Põhitekst
01.07.2001
Põhitekst
This European Standard specifies the dimensions, design, types, designation, materials and marking of spiral wound gaskets for use with type A flat face or type B raised face flange facings complying with EN 1759-1 for the following Class designations:
-  Class 150, to Class 1 500 for nominal sizes DN 15 to DN 600, and
-  Class designation 2 500 up to and including DN 300.
The centering rings for the spiral wound gaskets according to this standard are sized for use with imperial bolting.
The dimensions of spiral wound gaskets for tongue and groove flange facing types and spigot and recess flange facing types to EN 1759-1 are not included in this standard.
Such gaskets may be available, however, for these types of flange and the purchaser is advised to consult the manufacturer as to their availability. Similarly, for slip-on or screwed flange types, the manufacturer should be consulted about availability.
NOTE  Dimensions of other types of gasket for use with flanges complying with the requirements of EN 1759-1 are given in EN 12560-1, EN 12560-3, EN 12560-4 and EN 12560-5, EN 12560-6 and EN 12560-7.

Nõutud väljad on tähistatud *

*
*
*
PDF
15,86 € koos KM-ga
Paber
15,86 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN 1515-1:2000

Flanges and their joints - Bolting - Part 1: Selection of bolting
Uusim versioon Kehtiv alates 01.07.2000
Põhitekst

EVS-EN 12560-6:2004

Flanges and their joints - Gaskets for class-designated flanges - Part 6: Covered serrated metal gaskets for uses with steel flanges
Uusim versioon Kehtiv alates 13.05.2004