Skip to main content
Tagasi

EVS-EN 12201-2:2024

Plastics piping systems for water supply, and for drains and sewers under pressure - Polyethylene (PE) - Part 2: Pipes

Üldinfo

Kehtiv alates 15.02.2024
Alusdokumendid
EN 12201-2:2024
Tegevusala (ICS grupid)
23.040.20 Plasttorud
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
15.02.2024
Põhitekst
14.11.2013
Põhitekst + muudatus

EN 12201-2 specifies the characteristics of pipes made from polyethylene (PE) for buried and above-ground applications. These can be intended for the conveyance of water for human consumption, raw water before treatment, drains and sewers under pressure, vacuum sewer systems, and water for other purposes, except industrial applications. The intended uses include sea outfalls, laid in water and pipes suspended below bridges.

For use in contaminated soils, special consideration is taken for pipes intended for the transport of water intended for human consumption or raw water before treatment. It also specifies the test parameters for the test methods referred to in EN 12201-2.

EN 12201-2 can be applied to PE pipes, fitting and valves, their joints and joints with components of PE and other materials intended to be used under the following conditions:

 – allowable operating pressure, PFA, up to 25 bar,

 – an operating temperature of 20 °C as a reference temperature.

EN 12201-2 can be applied to three types of pipes:

— PE pipes (outside diameter dn) including any identification stripes,

— PE pipes with co-extruded layers on either or both the outside or inside of the pipe (total outside diameter dn) as specified in Annex B, where all PE layers have the same MRS rating,

— PE pipes (outside diameter dn) with a peelable and contiguous thermoplastics additional layer on the outside of the pipe (“coated pipe”) as specified in Annex C.

Nõutud väljad on tähistatud *

*
*
*
PDF
24,40 € koos KM-ga
PDF redline
31,72 € koos KM-ga
Paber
24,40 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN 12201-1:2024

Plastics piping systems for water supply, and for drains and sewers under pressure - Polyethylene (PE) - Part 1: General
Uusim versioon Kehtiv alates 15.02.2024
Põhitekst

EVS-EN 12201-3:2024

Plastics piping systems for water supply, and for drains and sewers under pressure - Polyethylene (PE) - Part 3: Fittings
Uusim versioon Kehtiv alates 15.02.2024
Põhitekst

EVS-EN 12201-4:2024

Plastics piping systems for water supply, and for drains and sewers under pressure - Polyethylene (PE) - Part 4: Valves for water supply systems
Uusim versioon Kehtiv alates 15.02.2024
Põhitekst

EVS-EN 12201-5:2024

Plastics piping systems for water supply, and for drains and sewers under pressure - Polyethylene (PE) - Part 5: Fitness for purpose of the system
Uusim versioon Kehtiv alates 15.02.2024