Skip to main content
Tagasi

ISO 7919-5:2005

Mechanical vibration -- Evaluation of machine vibration by measurements on rotating shafts -- Part 5: Machine sets in hydraulic power generating and pumping plants

Üldinfo

Kehtetu alates 20.07.2018
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
20.07.2018
Põhitekst
Põhitekst
Põhitekst
ISO 7919-5:1997
ISO 7919-5:2005 gives guidelines for applying evaluation criteria for shaft vibration measured at, or close to, the bearings of machines or machine sets in hydraulic power generating and pumping plants under normal operating conditions. These guidelines are presented in terms of both steady-state running vibration and any amplitude changes that can occur in these steady vibration values.
ISO 7919-5:2005 is applicable to machines or machine sets in hydraulic power generating and pumping plants where the hydraulic machines have speeds from 60 r/min to 1800 r/min, shell- or shoe-type sleeve bearings, and main engine power of at least 1 MW. The position of the shaft line can be vertical, horizontal or at an arbitrary angle between these two directions.
Machine sets covered by ISO 7919-5:2005 include a combination of hydraulic turbines and generators, pumps and electrical machines operating as motors, pump-turbines and motor-generators, and hydraulic turbines, pumps and motor-generators (classic pump-storage machine sets), including auxiliary equipment (e.g. starting turbines or exciters lying in the shaft line).
ISO 7919-5:2005 is also applicable to turbines or pumps connected to generators or electrical motors via gears and/or radially flexible couplings.
It is not applicable to pumps in thermal power plants or industrial installations, hydraulic machines or machine sets having rolling element bearings, or hydraulic machines with water-lubricated bearings.

Nõutud väljad on tähistatud *

*
*
*
PDF
82,61 € koos KM-ga
Paber
82,61 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

ISO 8573-4:2001

Compressed air -- Part 4: Test methods for solid particle content
Kehtetu alates 19.02.2019
Põhitekst

EVS-EN ISO 14122-1:2003

Masinate ohutus. Püsijuurdepääsuvahendid masinatele. Osa 1: Valik kahe tasandi vahelisi fikseeritud juurdepääsuvahendeid
Kehtetu alates 05.07.2016
Muudatus

EVS-EN ISO 14122-1:2003/A1:2010

Masinate ohutus. Püsijuurdepääsuvahendid masinatele. Osa 1: Valik kahe tasandi vahelisi fikseeritud juurdepääsuvahendeid
Kehtetu alates 05.07.2016
Põhitekst

EVS-EN ISO 14122-2:2003

Masinate ohutus. Püsijuurdepääsuvahendid masinatele. Osa 2: Tööplatvormid ja läbikäigud
Kehtetu alates 05.07.2016