Skip to main content
Tagasi

ISO 10816-4:2009

Mechanical vibration -- Evaluation of machine vibration by measurements on non-rotating parts -- Part 4: Gas turbine sets with fluid-film bearings

Üldinfo

Kehtetu alates 18.06.2018
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
18.06.2018
Põhitekst
Põhitekst
Põhitekst
ISO 10816-4:1998
ISO 10816-4:2009 establishes specific provisions for evaluating the severity of in-situ, broad-band vibration measured radial (i.e. transverse) to the shaft axis on all main bearing housings or pedestals and in the axial direction on thrust bearings. These are in terms of:
- vibration under normal steady-state operating conditions;
- vibration during other (non-steady-state) conditions when transient changes are taking place, including run up or run down, initial loading and load changes;
- changes in vibration which can occur during normal steady-state operation.
ISO 10816-4:2009 is applicable to heavy-duty gas turbine sets used in electrical and mechanical drive applications, with fluid-film bearings, outputs greater than 3 MW and an operating speed range under load between 3 000 r/min and 30 000 r/min.

Nõutud väljad on tähistatud *

*
*
*
PDF
82,61 € koos KM-ga
Paber
82,61 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 10439-1:2015

Petroleum, petrochemical and natural gas industries - Axial and centrifugal compressors and expander-compressors - Part 1: General requirements (ISO 10439-1:2015)
Uusim versioon Kehtiv alates 02.04.2015
Põhitekst

EVS-EN ISO 10439-2:2015

Petroleum, petrochemical and natural gas industries - Axial and centrifugal compressors and expander-compressors - Part 2: Non-integrally geared centrifugal and axial compressors (ISO 10439-2:2015)
Uusim versioon Kehtiv alates 02.04.2015
Põhitekst

EVS-EN ISO 10439-3:2015

Petroleum, petrochemical and natural gas industries - Axial and centrifugal compressors and expander-compressors - Part 3: Integrally geared centrifugal compressors (ISO 10439-3:2015)
Uusim versioon Kehtiv alates 02.04.2015
Põhitekst

ISO 10816-5:2000

Mechanical vibration -- Evaluation of machine vibration by measurements on non-rotating parts -- Part 5: Machine sets in hydraulic power generating and pumping plants
Kehtetu alates 20.07.2018