Skip to main content
Tagasi

EVS-EN ISO 8434-1:2018

Metallic tube connections for fluid power and general use - Part 1: 24° cone connectors (ISO 8434-1:2018, Corrected version 2018-10)

Üldinfo

Kehtiv alates 18.09.2018
Alusdokumendid
ISO 8434-1:2018; EN ISO 8434-1:2018
Tegevusala (ICS grupid)
23.100.40 Torustikud, toruliited
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
18.09.2018
Põhitekst
07.05.2009
Parandus
05.12.2007
Põhitekst
This document specifies the general and dimensional requirements for 24° cone connectors using cutting ring and O‑ring seal cone (referred to as DKO) suitable for use with ferrous and non‑ferrous tubes with outside diameters from 4 mm to 42 mm inclusive. These connectors are for use in fluid power and general applications within the limits of pressure and temperature specified in this document.
They are intended for the connection of plain end tubes and hose fittings to ports in accordance with ISO 6149‑1, ISO 1179‑1 and ISO 9974‑1. (See ISO 12151‑2 for a related hose fitting specification.)
These connectors provide full-flow connections in hydraulic systems operating to the working pressures shown in Table 1. Because many factors influence the pressure at which a system performs satisfactorily, these values are not intended to be understood as guaranteed minimums. For every application, sufficient testing is meant to be conducted and reviewed by both the user and manufacturer to ensure that required performance levels are met.
NOTE 1 For new designs in hydraulic fluid power applications, see the requirements given in 9.6. Where the requirements of the application allow for the use of elastomeric seals, connector designs that conform to International Standards and incorporate elastomeric sealing are preferred.
NOTE 2 For use under conditions outside the pressure and/or temperature limits specified, see 5.4.
This document also specifies a performance and qualification test for these connectors.

Nõutud väljad on tähistatud *

*
*
*
PDF
31,72 € koos KM-ga
Paber
31,72 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 7010:2020

Graphical symbols - Safety colours and safety signs - Registered safety signs (ISO 7010:2019, Corrected version 2020-06)
Kehtiv alates 02.04.2020
Muudatus

EVS-EN ISO 7010:2020/A1:2020

Graphical symbols - Safety colours and safety signs - Registered safety signs - Amendment 1 (ISO 7010:2019/Amd 1:2020)
Kehtiv alates 15.10.2020
Põhitekst

EVS-EN 10216-5:2021

Terasest õmblusteta survetorud. Tehnilised tarnetingimused. Osa 5: Roostevabast terasest torud
Uusim versioon Kehtiv alates 01.11.2021
Põhitekst

EVS-EN 857:2015

Rubber hoses and hose assemblies - Wire braid reinforced compact type for hydraulic applications - Specification
Uusim versioon Kehtiv alates 07.05.2015