Skip to main content
Tagasi

EVS-EN ISO 16859-2:2015

Metallic materials - Leeb hardness test - Part 2: Verification and calibration of the testing devices (ISO 16859-2:2015)

Üldinfo

Kehtiv alates 04.11.2015
Alusdokumendid
ISO 16859-2:2015; EN ISO 16859-2:2015
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
04.11.2015
Põhitekst
This part of ISO 16859 specifies methods for direct and indirect verification of test instruments used for determining Leeb hardness in accordance with ISO 16859-1, and also describes when these two types of verification shall be performed.
The direct verification involves checking that individual instrument performance parameters fall within specified limits, whereas the indirect verification utilizes hardness measurements of reference test blocks, calibrated in accordance with ISO 16859-3, to check the overall performance of the instrument. The indirect method may be used on its own for the periodic performance checking in service.
NOTE°1 Direct verification of test instruments included in this standard can only be done where applicable reference values are provided by the instrument manufacturer.
NOTE°2 For testing in directions other than in direction of gravity, the measured hardness number will be biased. For such cases, the correction values shall be provided by the manufacturer.

Nõutud väljad on tähistatud *

*
*
*
PDF
15,86 € koos KM-ga
Paber
15,86 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 16859-1:2015

Metallic materials - Leeb hardness test - Part 1: Test method (ISO 16859-1:2015)
Uusim versioon Kehtiv alates 04.11.2015
Põhitekst

EVS-EN ISO 16859-3:2015

Metallic materials - Leeb hardness test - Part 3: Calibration of reference test blocks (ISO 16859-3:2015)
Uusim versioon Kehtiv alates 04.11.2015
Põhitekst

EVS-EN ISO 15480:2019

Fasteners - Hexagon washer head drilling screws with tapping screw thread (ISO 15480:2019)
Uusim versioon Kehtiv alates 01.08.2019
Põhitekst

EVS-EN ISO 1207:2011

Soonega silinderpeakruvid. Tooteklass A (ISO 1207:2011)
Uusim versioon Kehtiv alates 06.09.2011