Skip to main content
Tagasi

EVS-EN ISO 15874-1:2013

Plastics piping systems for hot and cold water installations - Polypropylene (PP) - Part 1: General (ISO 15874-1:2013)

Üldinfo

Kehtiv alates 05.03.2013
Alusdokumendid
ISO 15874-1:2013; EN ISO 15874-1:2013
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
15.11.2022
Põhitekst + muudatus
15.07.2022
Muudatus
05.03.2013
Põhitekst
This part of ISO 15874 specifies the general aspects of polypropylene (PP) piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water whether or not intended for human consumption (domestic systems), and for heating systems, under design pressures and temperatures according to the class of application (see Table 1). It covers a range of service conditions (classes of application), design pressures and pipe dimension classes. For values of TD, Tmax and Tmal in excess of those in Table 1 of this part of ISO 15874 do not apply. NOTE It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes. It also specifies the test parameters for the test methods referred to in this part of ISO 15874. In conjunction with the other parts of ISO 15874, this part of ISO 15874 is applicable to PP pipes, fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for hot and cold water installations.

Nõutud väljad on tähistatud *

*
*
*
PDF
15,86 € koos KM-ga
Paber
15,86 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 15874-5:2013

Plastics piping systems for hot and cold water installations - Polypropylene (PP) - Part 5: Fitness for purpose of the system (ISO15874-5:2013)
Uusim versioon Kehtiv alates 05.03.2013
Muudatus

EVS-EN ISO 15874-5:2013/A1:2018

Plastics piping systems for hot and cold water installations - Polypropylene (PP) - Part 5: Fitness for purpose of the system - Amendment 1 (ISO 15874-5:2013/Amd 1:2018)
Uusim versioon Kehtiv alates 16.08.2018
Muudatus

EVS-EN ISO 15874-3:2013/A2:2021

Plastics piping systems for hot and cold water installations - Polypropylene (PP) - Part 3: Fittings - Amendment 2 (ISO 15874-3:2013/Amd 2:2021)
Kehtiv alates 15.11.2021
Põhitekst

EVS-EN ISO 1452-5:2011

Plastics piping systems for water supply and for buried and above-ground drainage and sewerage under pressure - Unplasticized poly(vinyl chloride) (PVC-U) - Part 5: Fitness for purpose of the system (ISO 1452-5:2009, corrected version 2010-03-01)
Uusim versioon Kehtiv alates 02.06.2011