Skip to main content
Tagasi

EVS-EN ISO 10350-1:2008

Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials

Üldinfo

Kehtetu alates 18.12.2017
Alusdokumendid
ISO 10350-1:2007; EN ISO 10350-1:2008
Tegevusala (ICS grupid)
83.080.20 Termoplastid
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
18.12.2017
Põhitekst
04.08.2014
Muudatus
07.10.2008
Põhitekst
Põhitekst
EVS-EN ISO 10350-1:2001
ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets. This part of ISO 10350 applies predominantly to unreinforced and reinforced thermoplastic and thermosetting materials that may be injection- or compression-moulded or prepared as sheets of specified thickness. Part 2 of ISO 10350 deals specifically with long- or continuous-fibre-reinforced plastics. For the purposes of ISO 10350, long-fibre-reinforced plastics are considered to have fibre lengths greater than 7,5 mm prior to moulding.

Nõutud väljad on tähistatud *

*
*
*
PDF
12,20 € koos KM-ga
Paber
12,20 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring