Skip to main content
Tagasi

EVS-EN 10270-3:2011

Steel wrie for mechanical springs - Part 3: Stainless spring steel wire

Üldinfo

Kehtetu alates 15.09.2020
Alusdokumendid
EN 10270-3:2011
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
15.09.2020
Põhitekst
05.12.2011
Põhitekst
Põhitekst
EVS-EN 10270-3:2001
1.1 This European Standard applies to the grades of stainless steels listed in Table 1, which are usually used in the cold drawn condition in the form of wire of circular cross-section up to 10,00 mm in diameter, for the production of springs and spring parts that are exposed to corrosive effects and sometimes to slightly increased temperatures (see A.1). 1.2 In addition to the steels listed in Table 1 certain of the steel grades covered by EN 10088-3 e.g. 1.4571, 1.4539, 1.4028 are also used for springs, although to much lesser extent. In these cases the mechanical properties (tensile strength, etc.) should be agreed between purchaser and supplier. Similarly, diameters between 10,00 mm and 15,00 mm may be ordered according to this standard; in this case the parties should agree upon the required mechanical characteristics. 1.3 In addition to this European Standard the general technical delivery requirements of EN 10021 are applicable.

Nõutud väljad on tähistatud *

*
*
*
PDF
19,52 € koos KM-ga
Paber
19,52 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN 10270-2:2011

Steel wire for mechanical springs - Part 2: Oil hardened and tempered spring steel wire
Uusim versioon Kehtiv alates 05.12.2011
Põhitekst + muudatus

EVS-EN 10270-1:2011+A1:2017

Steel wire for mechanical springs - Part 1: Patented cold drawn unalloyed spring steel wire
Kehtetu alates 15.03.2024
Põhitekst

ISO 13854:1996

Safety of machinery -- Minimum gaps to avoid crushing of parts of the human body
Kehtetu alates 10.11.2017
Põhitekst + muudatus

EVS-EN 60079-0:2013+A11:2014

Plahvatusohtlikud keskkonnad. Osa 0: Seadmed. Üldnõuded
Kehtetu alates 16.07.2018