This part of EN 1852 specifies the requirements for solid wall pipes with smooth internal and external
surfaces extruded from the same compound/formulation throughout the wall, fittings and the system of
polypropylene (PP) piping systems intended for use for:
— non-pressure underground drainage and sewerage outside the building structure (application area
code “U”), and
— non-pressure underground drainage and sewerage for both buried in ground within the building
structure (application area code “D”) and outside the building structure.
This is reflected in the marking of products by “U” and “UD”.
This standard covers PP materials without mineral modifiers.
It also specifies the test parameters for the test methods referred to in this standard.
NOTE 1 Solid wall multilayer pipes with different formulation throughout the wall and foamed core pipes are
covered by EN 13476-2 [1] (see also CEN ISO/TR 27165 [2]).
This standard covers a range of nominal sizes, and pipe series and gives recommendations concerning
colours.
NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selection from these
aspects, taking into account their particular requirements and any relevant national regulations and installation
practices or codes.
In conjunction with CEN/TS 1852-2, it is applicable to PP pipes and fittings, their joints and to joints
with components of other plastics and non-plastics materials intended to be used for buried piping
systems for non-pressure underground drainage and sewerage.
The fittings can be manufactured by injection-moulding or be fabricated from pipes and/or mouldings.
NOTE 3 Pipes, fittings and other components conforming to any of the plastics product standards listed in
Annex C can be connected to pipes and fittings conforming to this standard, when they conform to the
requirements for joint dimensions given in Clause 6 and to the requirements of Table 14.
Required fields are indicated with *
